Tech Update: Painting over intumescent strips

Details

Intumescent strips are fitted to doors to swell in the event of a fire, thus sealing the door to frame gap.

An intumescent strip is often installed as a combined unit which incorporates a fire resisting material and a cold smoke seal. The intumescent material expands on exposure to heat, sealing the door once a fire has taken hold. The brush or vinyl blade, which is effectively a draught excluder, helps prevent smoke getting past the door in the early stages of a fire.

If painted over, does this affect the integrity of the ‘Intumescent strips’ in the event of a fire?

 

The Standards

BS8214:2008, The Code of Practice for Fire Door Assemblies; states: Painting of smoke seals or combined intumescent & smoke seals should be avoided.

If your fire doors are protected with a simple intumescent strip only (without a cold smoke seal) they can be over painted as long as it isn’t damaged by the painter’s preparation. Heavy sanding or the use of chemical strippers and heat guns during redecoration must be avoided.

BS8214 states that you can put a maximum of five coats of conventional oil bound paint or varnish on the strip without damaging its effectiveness.

 

Recommendations

You can only over paint an intumescent strip which is designed for fire protection. You must not over paint a smoke seal. Also, be careful to ensure that the strip isn’t damaged by the painter’s preparations.

 

References

British Standards – BS 8214 Code of Practice for fire door assemblies

 

Introduction

This Technical Update article provides additional guidance on painting over intumescent strips. It is important that all workmanship carried out during construction is completed in accordance with the relevant tolerances.

Download a PDF version of this article

Want to download a version of this article?

Download PDF

Every care was taken to ensure information in this article was correct at the time of writing. Guidance provided does not replace the reader’s professional judgement and any construction project should comply with the relevant building regulations or applicable technical standards. For the most up to date LABC Warranty technical guidance please refer to your risk management surveyor and the latest version of the LABC Warranty Technical Manual.

Related Articles

New homes built alongside or attached to existing homes

Considerations and recommendations for building new homes attached to existing homes within warranty requirements.
Read More

Warranty requirements for vertically stacked coupled window assemblies

Warranty requirements for vertically stacked coupled window assemblies including testing, structural integrity, and more.
Read More

Using cavity trays at DPC level for timber frame construction

Guidance on the use of cavity trays at DPC level in timber frame construction, and how they can impact drainage and ventilation...
Read More