See anything wrong in this photo? Identify 3 things to look out for when installing DPC

The photograph below was taken by one of LABC's building control surveyors when carrying out a site inspection, and shows how attention to detail (or a lack of!) can lead to future problems. This extension will suffer from moisture problems, but there is not one reason why – there are three.

Look closely at the DPC arrangement.

The result?

The blockwork above the DPC will become saturated and cause damp problems within the extension, the skirting boards will rot and the mould will occur on the plaster. This could have been avoided by building the membrane on to the inner leaf only and protecting it with a 100mm DPC, or by protecting the wide horizontal DPC with an additional cavity tray over.

Now look at the blockwork in the reveal for the door.

The full picture shows that the contractor has built in a vertical DPC where the two wall leaves meet to prevent moisture tracking across. But in our ‘cropped’ part of the picture this is not visible – mortar has been smeared over the joint, making the vertical DPC useless at this junction.

The reveal has no insulation at all...

Just solid masonry separated by a vertical DPC. This means that this part of the wall will be colder than the rest of the wall, resulting in condensation forming around this part of the structure – a case of ‘cold bridging’.

Judging by the standards of workmanship, it’s quite likely that there is no insulation below the DPC either, meaning the same problems will happen around the skirting too. It’s important to think about cold bridging through any part of the structure but especially where junctions occur. Use of an insulated cavity closer would have prevented these last 2 problems.

For more information about preventing cold bridges, refer to LABC's Registered Construction Details or visit

Please Note: Every care was taken to ensure the information in this article was correct at the time of publication. Any written guidance provided does not replace the reader’s professional judgement and any construction project should comply with the relevant Building Regulations or applicable technical standards. However, for the most up to date LABC Warranty technical guidance please refer to your Risk Management Surveyor and the latest version of the LABC Warranty technical manual.

Was this post helpful? /