Reducing the effects of ground heave following tree removal

What affects the amount of heave following tree removal?

  • Maturity of the tree
  • Permeability of the soil
  • Availability of free water

It is difficult to say exactly how long it will take for the ground to recover. It can take as little as a few winter months up to as many as 25 years!

However the points above will help to give you an idea of what will affect the amount of heave and thus the recovery time of the soil.

In other words the more mature the tree the more water it would have absorbed and thus the more movement that will occur as the water finds a new place to go.


What can you do to reduce the effects of heave?

1. Allow for the possibility of heave where existing trees may mature or die

If a tree exists within the plot you are building on there is a probability that it could die at some point during the lifecycle of the building. This is especially the case where the tree has dried out the soil prior to foundations being laid.

To alleviate issues of soil swelling from existing trees you can sever the roots within the footprint of the building’s foundations to allow the soil to rehydrate.

2. Determine foundation depth for your ground conditions

The easiest way to determine the correct depth for your foundations when it comes to trees is to use our Foundation Depth Calculator.

This will take into account the proximity of the tree and the type of soil, among other factors, to calculate the depth required up to a maximum depth of 2.5m.

Foundations in excess of 2.5m will require a site-specific assessment to be undertaken by a suitably qualified and experienced expert.

3. Consider alternative methods of foundations

The depth of the foundations required will determine which foundation method is most suitable.

For example, for depths up to 1.5m, trench fill foundations may be the most economic but for those in excess of 2m, pile foundations with ground beams would be recommended.

If the foundation depth is greater than 1.5m, a proprietary compressible material must be placed on all inside surfaces of the peripheral foundations to allow for lateral soil swelling, as shown in the diagrams below.



figure-8_350x363 (1)

For more information on foundations, trees and clay check out Section 5.2 of our Technical Manual.

Foundations can be difficult enough to get right without the added problem of nearby or pre-existing trees.

We have already covered what you need to know when building near trees so now we are going to focus on how to reduce the effects of heave after a tree has been removed.

First off let’s explain what heave is and why this is bad for your build.

When a tree is removed from the soil water is no longer being absorbed by the tree roots, meaning the soil will start to swell as it gets wet.

Think of a puffer fish when it ‘puffs up’ and doubles in size!

Okay maybe not quite, but this swelling can cause the soil to uplift, sometimes to a greater volume than when the property was built, leading to displacement of the foundations.

Subscribe to the LABC Warranty blog for guidance like this delivered to your inbox

Subscribe to the blog

Every care was taken to ensure information in this article was correct at the time of writing. Guidance provided does not replace the reader’s professional judgement and any construction project should comply with the relevant building regulations or applicable technical standards. For the most up to date LABC Warranty technical guidance please refer to your risk management surveyor and the latest version of the LABC Warranty Technical Manual.

Related Articles

Roof integrated PV solar panels

Learn about the requirements and considerations for roof integrated PV solar panel systems in this technical update.
Read More

Deflection heads – avoiding accidental loading of non-load bearing internal walls

Learn about preventing accidental loading of non-load bearing internal walls with deflection heads.
Read More

New homes built alongside or attached to existing homes

Considerations and recommendations for building new homes attached to existing homes within warranty requirements.
Read More